35
X
SECTION 6 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
6.5
6.4
Wood Block
• While two people continue to hold the assembly in place, set a block of Scrap Wood on top of the Rigid Arms
and strike it 5-6 times with a hammer or mallet.
You must have wood on top of the Arms before hitting them with a
hammer to prevent scratching the powder coating.
The bottom edge of the Middle Pole must reach within 1/2 inch of
the 5-inch mark on the Bottom Pole.
• After the Poles have been seated, measure up 1" from the bottom center of the
Middle Pole (ALF)
and insert one
Self-Tapping Screw (CMV)
into the Pole as shown.
• The Poles must be seated together! Even if the Poles cover the
slots before seating, they must be struck on a hard surface
fi ve to six times! Failure to seat the Poles correctly could allow
the Poles to separate during use, which could lead to serious
personal injuries or property damage.
• If your Pole sections do not reach within 1/2" of the 5"
mark after seating, DO NOT COMPLETE ASSEMBLY. Call
our Customer Service number for assistance.
!
!
(x1)
CMV
ALH
CMV
(x1)
1" up from bottom of
Top Pole
(x1)
(x1)
