19
X
SECTION 4 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
4.1
• Finger-tighten the
Short
Extension Arms (AKC)
to the Backboard Brackets with the hardware shown.
4.2
• Finger-tighten the
Long
Extension Arms (AKB)
to the Backboard Brackets with the hardware shown. If needed, use a
rubber mallet to tap the bolt into place.
AAX
(x2)
DFB
(x2)
7 1/2”
DGA
(x2)
ABN
(x4)
AAX
AAX
AKB
AKB
AKB
DGA
DGA
DFB
DFB
ABN
ABN
AKC
AKC
ABN
ABN
• If you experience diffi culty passing the
bolt through the holes, try using a wrench
to rotate the bolt until it passes through.
DO NOT STRIKE THE BOLT to assist it
through the holes in this step.
!
3/4”
(x2)
• If you experience
diffi culty passing the
bolt through the holes,
try using a wrench to
rotate the bolt until it
passes through. DO
NOT STRIKE THE BOLT
to assist it through the
holes in this step.
!
• If necessary, use a bolt to remove any
excess powder coating from the holes in the
Backboard Brackets.
!
