9
ASSEMBLY INSTRUCTIONS
IV. ASSEMBLY INSTRUCTION
Tools Required Assembling the equipment: One Adjustable Wrench and one Allen Wrench
NOTE:
It is strongly recommended two or more people assembling this equipment to avoid
possible injury.
STEP 1 (See diagram 1)
A. Attach two Frames (#A) to the upper two holes on a 6-hole Bracket (#1). Attach two Frames (#A)
to the lower two holes on the same 6-hole Bracket (#1). Make sure the Frames are behind the
Bracket as shown in Diagram-1 below.
B. Secure each Frame to the Bracket with one M8 x 15MM Allen Bolt and M8 Domed nylock Nut.
Do not fully tighten the Nut and Bolt yet.
C. Repeat Procedures A & B above to assemble Three more sets (Total four sets) and let’s call it
“Frame X” for easier identification.
DIAGRAM 1
#A
#1
#A
