- 18 -
- 15 -
WATER CONNECTION
：
1. The ice maker must use room temperature filtered drinking water.
2. The water pressure of the water supply must be controlled between 100kpa and 800kpa.
A pressure relief valve is required for over pressure. Do not squeeze the water inlet hose.
3. At the same time of feeding the tap water, the bucket water inlet valve must be closed.
4. When using bucket water, please plug the inlet valve with a plug to prevent water
leakage.
5. Please note the "Water inlet port" and "Water draining port" signs at the interface.
6. The ice maker's drainage depends on gravity, so the drainage pipe must have sufficient
slope and drop.
WATER PIPE INSTALL
Water Tank Drain Pipe Install
Water Inlet Pipe Install
Remove the plug
Insert the Drain Pipe and
install the Snap Spring
1. Insert the 1/4 Inlet Pipe
2. Put on the Blue Buckle
Installation steps of bucket water inlet mode
Step 1: Hook up the drain hose
1.Pull out the water outlet plug
(Not
sewage outlet plug)
2.Insert the drain hose and install the
snap spring
to fix the drain hose.
Step 2: Adjust the valve to the bucket water inlet mode
Step 3: Install the water jug
1.Adjust the valve to the direction
parallel to the water pipe.
(bucket
water inlet mode)
1.Variety of water jugs are
applicable. The diameter of the
water jug outlet needs to be less
than 3.2 inches. If water cannot
enter, try lifting the jug several
times to exhaust the air.
