LifeFitness DISCOVER SE3, Руководство по эксплуатации

Страница: 72 / 77

71
TROUBLESHOOTING
Malfunction Probable Cause Corrective Action
No power.
ON / OFF switch is not in proper position . Turn the switch to the ON position.
Power source is insuffi cient
Plug treadmill into a dedicated 20 amp cir-
cuit. Using a voltmeter, verify power at out-
let. If no power exists, reset circuit breaker at
panel.
Line cord is damaged.
Replace line cord. Contact Life Fitness Cus-
tomer Support Services.
Line cord is improperly seated in socket.
Inspect power connection at wall outlet and
at machine for proper contact.
Note: International Platinum Club Se-
ries Treadmills (PCST) only:
You may be
in “Energy Saving Mode”.
Treadmill will go into Energy Saving Mode
after 5 minutes of inactivity. To wake up
the console, step on the treadmill belt. The
treadmill will automatically wake up and the
console will light up. Waking up the tread-
mill takes approximately 50 seconds after
stepping onto the belt.
Note: International Platinum Club Se-
ries Units only (PCSC, PCSR, PCSX ): You
may be in “Energy Saving Mode”.
Unit will go into Energy Saving Mode after 5
minutes of inactivity. To wake up the con-
sole, pedal until you hear a beep. The unit
will automatically wake up and the console
will light up. Waking up the unit takes ap-
proximately 50 seconds after beginning to
pedal.
Treadmill striding belt
slips
off-center.
Floor surface is uneven.
Check levelers and level treadmill. Check
striding belt & re-tension as necessary.
Refer to
Elevation Series 95T Treadmill &
PCS Treadmill Discover SE3, Discover SI, &
Explore Assembly Instructions.
Maximum treadmill
speed is
reduced.
User is pushing striding belt. This occurs
when the runner is running faster than the
striding belt will travel, with the result of
the striding belt being pushed with the
runner’s feet.
Instruct users not to push striding belt in
either direction.
User is stalling striding belt. This will occur
with heavier users at lower striding belt
speeds. The striding belt will “stall” if the
user is traveling slower than the striding
belt speed.
Striding belt/deck malfunctions. The deck
laminate is worn through or the under-
side of striding belt is glazed over (hard,
glossy).
Replace belt and deck. Contact Life Fitness
Customer Support Services.
Power source is insuffi cient.
Plug treadmill into a dedicated 20 amp
circuit.
Rubbing sound comes
from
underneath treadmill.
Foreign objects may be stuck underneath
the machine.
Inspect underneath striding belt and ma-
chine. Remove any debris or objects that
may cause interference with the treadmill.
Display does not
illuminate when
machine is powered on.
Loose connection at display console or
motor control board.
Check all electrical connections for proper
attachment. Contact Life Fitness Customer
Support Services.