9
3. Handlebar Post and Tension Control Knob Installation
Remove four M8x15 Bolts (38) and four Ø20xØ8 Curve Washers (37) from the Main Frame
(1). Remove bolts with the S6 Allen Wrench provided.
Insert the Tension Cable (27) through into the bottom hole of Handlebar Post (3) and pull it
out from the square hole of Handlebar Post (3).
Connect the Sensor Wire (60) from the Main Frame (1) to the Extension Sensor Wire (28)
from the Handlebar Post (3).
Insert the Handlebar Post (3) onto the tube of the Main Frame (1) and secure with four
M8x15 Bolts (38) and four Ø20xØ8 Curve Washers (37) that were removed. Tighten bolts
with the S6 Allen Wrench provided.
Remove the Ø5 Big Curve Washer (23) and M5x45 Bolt (24) and from the Tension Control
Knob (22). Remove bolt with the Multi Hex Tool with Phillips Screwdriver provided.
Put the cable end of resistance cable of Tension Control Knob (22) into the spring hook of
Tension Cable (27) as shown in drawing A of figure 3. Pull the resistance cable of Tension
Control Knob (22) up and force it into the gap of metal bracket of Tension Cable (27) as
shown in drawing B of figure 3. Attach the Tension Control Knob (22) onto the Handlebar
Post (3) with the Ø5 Big Curve Washer (23) and M5x45 Bolt (24) that were removed.
Tighten bolt with the Multi Hex Tool with Phillips Screwdriver provided.
38
37
38
38 37
3
27
22
24 23
37
1
28
60
Allen Wrench S6
Tool:
Multi Hex Tool with Phillips Screwdriver
S10, S13, S14, S15
A
B
27
27
22
22
