STEP 13:
• Insert the two GUIDE RODS (37) (found in SHROUD KIT box) into the base of the TOWER (1) as shown in FIGURE 13. Lubricate
the GUIDE RODS (37) with a slicon or teflon spray that is available at most hardware stores.
• Slide two WEIGHT STACK CUSHIONS (28) down over the GUIDE RODS (37). See FIGURE 13.
• Using
EXTREME CARE
place fifteen 10 LB. WEIGHT PLATES (38) over the GUIDE RODS (37) as shown in FIGURE 13.
(NOTE:
If HEAVY WEIGHT OPTION is being used, slide ten 15LB. WEIGHT PLATES (39) over the GUIDE RODS (37) first, then
slide five 10 LB. WEIGHT PLATES (38) over the GUIDE RODS.)
• Carefully Slide the HEAD PLATE (11) down over the GUIDE RODS (37) onto the weight stack as shown in FIGURE 13.
• Slide one WEIGHT STACK SELECTOR PIN (27) over the shaft on the HEAD PLATE (11) as shown in FIGURE 13.
FIGURE 13
12
• Slide two GUIDE ROD BUSHINGS (32) over each GUIDE ROD(37)
• Slide two 1” SHAFT COLLARS (30) over each GUIDE ROD (37) as shown in FIGURE 13.
• Place the GUIDE ROD SUPPORT (5) over the GUIDE RODS (37) as shown in FIGURE 13.
28
38
37
11
27
30
32
5
1
38
39
HEAVY WEIGHT
OPTION
