Lifan LF 150-10B, Руководство пользователя

Страница: 19 / 24

Installation shall be done in the reverse order of
removal.
NOTES
Tightening torque of rear axle nut: 50 60N.m
For adjustment of the rear brake and chain, refer to
related items prescribed in the manual.
FUSE
(Fig. 41)
The fuse is positioned behind the left side cover near
the battery stay. The fuse will blow to protect the cir-
cuit automatically in the case of troubles such as a
short circuit or an overload trouble. After the
troubleshooting, fit a new fuse available in the fuse
box.
Fig. 39
Front axle
Speed sensor
Fig. 40
Locknut
Rear axle
Fuse
Fig. 41
BATTERY (EP)
(Fig. 42)
The battery is located behind the left cover of vehicle.
Maintain it in accordancde with the Maintenance Sched-
ule in the manual. The battery electrolyte level should be
between the UPPER level mark and LOWER level mark.
Should battery electrolyte level be below the LOWER
level mark, add proper distilled water to the UPPER level
mark. Be careful not to exceed the UPPER mark when
adding distilled water. Otherwise, overflowing electrolyte may cause corrosion.
CAUTION Be sure not to discard the battery electrolyte or used battery. Handle in
accordance with national or local environmental protection rules. Avoid entering water
around the battery when washing the vehicle.
WARNING If the battery is to be removed, disconnect the negative lead “ ” from the
battery terminal first, and then the position lead “+”. Connection should be done in the
reverse order of removal. Do not touch the positive lead to the vehicle body to prevent short-
circuiting. The leads should be tightened securely, or spark may occur to cause a fire.Make
sure that the duct of battery keeps unblocked, or the battery may be explosive under
certain conditions. The battery, in addition, should be equipped with an exhaust pipe,
otherwise, overflowing electrolyte (sulfuric acid) may erode the vehicle body, main cable,
even causing a fire by short-circuiting.
CAUTION The battery contains sulfuric acid (electrolyte). Contacting with skin
or eyes may cause severe burns. If such case occurs, flush with water for at least 5 minutes
and call a physician immediately. Please protective clothing and a face shield. Keep out
of reach of children. Do not use a new battery until taking a 30-minute wait after adding
liquid. If the engine fails to be started with the electric starter and the neutral light is dim,
use the kick-starter to start the engine. For prolonging the service, please start the engine
using the kick-starter when the air temperature is lower. Charge the battery at a rate less
than 1A for 10-15 hours if necessary. For further details, refer to Operating Instructions
of Battery.
Fig. 42
FRONT WHEEL
(Fig. 39)
To remove the front wheel, support the motorcycle
on the center stand, loosen the lock screw, remove
the speed sensor, extract the front axle, and remove
the front wheel.
NOTES
Installation shall be done in the reverse order of
removal.
Tightening torque of front axle nut: 45
55N.m
REAR WHEEL
(Fig. 40)
Support the motorcycle on the center stand, drive out bolts of brake caliper, remove the
brake caliper. Loose both locknuts, remove the chain. Unscrew the rear axle nut, remove
the rear axle and wheel in due succession.
ＬＦ １５０－１０Ｂ（ＥＮＧＬＩＳＨ）Ａ．ｐ６５
2012-4-23, 9:33 19