6
Heat Pump Water Heater
-
5
0
Hz (R134a)
4. Function List
Note
• These functions must be applied according to the model. Please refer to the follow ing function list for each model.
• ¹ : This function can be operated only w hen the w ired remote controller is connected. The applicability of each function depends on
the above table.
• ² : Optional accessories must be purchased separately. If show n as "Embedded", this function is included in product.
• The function Wi-Fi is only compatible w ith 2.4 GHz band. (802.11 b/g/n)
• Some specifications may be changed w ithout notifications due to our policy of innovation.
The air conditioner which DRED is available is capable of DRM1,DRM2 and DRM3 and complies with standard AS/NZS 4755.3.1.
•
Category
Function
Description
Air
Purifying Prefilter (Washable / Anti‐Bacteria)
Capture dust particles over 10μm in size and finer bacteria
Reliability
Self Diagnosis
Self‐diagnostic for product protection
De‐ice Control (Defrost)
In this mode, de‐icing of the evaporator automatically
Convenience
HeatPump
This mode minimizes power consumption by using only heat pump for heating.
Auto
This mode provides relatively low power consumption and high recovery.
This mode primary uses heat pump for heating
This mode is factory set mode for shipping
Turbo
This mode provides the highest recovery.
This mode uses heat pump and heating element simultaneously
Vacation
This feature is recommended when the water heater is not in used for an extended period of time.
In this mode, tank temperature will be maintained at about 68
°
F to minimize energy consumption and prev
ent the water heater from freezing.
Schedule
The Custormer can set up the operation time and mode based on their Demand Condition.
Auto Restart Operation
If power is resupplied after blackout, product restart automatically
Two Thermistor Control ¹
If there is a temperature difference between room temperature and desired temperature, you can use this
function in other to prevent insufficient cooling and insufficient heating
Overheating Protection
If there is a temperature difference between room temperature and desired temperature, you can use this
function in other to prevent over‐heating
Indoor Unit Display Type
‐
Indoor Unit Display Light
Set the brightness of the display on the indoor unit
Anti
-
legionella
Activates the water disinfection function. The water temperature reaches 60°C during a cycle.
Individual
Control
Wired Remote Controller ²
‐
Handheld Wireless Controller
‐
CAC
Network
Function
General Central Controller (Non LGAP)
‐
Network Solution (LGAP)
‐
Dry Contact ²
‐
PDI (Power Distribution Indicator) ²
‐
Outdoor Unit PI 485 ²
‐
Special
Function
Kit
Wi‐Fi ²
Easily access and control an water heater’s functions from anywhere
Water Level Sensor Connection ²
Detect the water level in drain pan
Crank Case Heater
Pre‐heating the compressor during winter
Smart Inverter Monitoring System (SIMs) ²
Help you to easily monitor, diagnose the air conditioner and get a quick resolution
Others
Temperature Control
Basic cycle control method