LG KI-14U30, Руководство пользователя

Страница: 3 / 25

Installation
Contents
Power
This set operates on a mains supply of 230V AC, 50Hz. In the
event of thunderstorms or powercuts, please pull out the aerial and
mains plugs.
Wiring
This set is supplied with a BS 1363 approved 13 amp mains plug,
fused at 5 amp. When replacing the fuse always use a 5 amp BS
1362, BSI or ASTA approved type. Never use this plug with the
fuse cover omitted. To obtain a replacement fuse cover contact
your dealer or "LG Electronics U.K. Ltd.".
If the type of plug supplied is not suitable for the mains sockets in
your home, then the plug should be removed and a suitable type
fitted. Please refer to the wiring instructions below:
Warning
A mains plug removed from the mains lead of this set must be
destroyed. A mains plug with bared wires is hazardous if inserted
in a mains socket.
Do not connect either wire to the earth pin, marked with the letter E
or with the earth symbol or coloured green or green and yellow.
If any other plug is fitted, use a 5 amp fuse, either in the plug, or at
the distribution board.
Important
The wires in this mains lead are coloured in accordance with the
following codes:
BLUE: NEUTRAL
BROWN: LIVE
As the colours of the wires in the mains lead of this set may not
correspond with the coloured marking identifying the terminals in
your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black. The wire which
is coloured brown must be connected to the terminal which is
marked with the letter L or coloured red.
Service
Never remove the back cover of the set as this can expose you to
very high voltage and other hazards. If the set does not operate
properly, unplug it and call your dealer.
Aerial
Connect the aerial cable to the socket marked
+
75 § Ù on the back
cover. For the best reception an outdoor aerial should be used.
Location
Position your set so that no bright light or sunlight falls directly onto
the screen. Care should be taken not to expose the set to any
unnecessary vibration, moisture, dust or heat. Also ensure that the
set is placed in a position to allow a free flow of air. Do not cover
the ventilation openings on the back.
Moisture condensation
Under special conditions, like moving your set from a cold to a
warm room, moisture condensation can build up on the head drum,
one of the most crucial parts of each VCR.
In order to prevent in such case any damage to your VCR HEAD
DRUM, connect the set power cord to the AC line, switch on the
main power button on the back cover and allow at least 2 hours for
the set to dry out.
Condensation is likely to occur when:
1. The video recorder is moved from a cold room to a warm room
or from outdoors to inside your home.
2. A cold room is heated quickly.
3. The humidity is very high.
3