23
OPERATION
ENGLISH
Water Hardness Table
*1 The number of water softerner regeneration(s)
: The number of wash cycle(s)
*2 A water softner regeneration takes place at the end of a main wash operation according to the
ECO
programme.
*3 A wash cycle consists of 4 operations(Pre-wash, Main wash, Rinse, Heating rinse) according to the
ECO
programme.
Setting the Water Softening
System
For effective washing results, adjust the setting
corresponding to the hardness level of water used
in water supply. The water softener has 5
adjustment levels, and the appliance is
programmed at the factory for a water hardness
level of H2. You can check the default setting value
and adjust it in the following steps:
1
Press
Power
and
Half Load
button
simultaneously.
• Current setting value indicated.
2
Press the
Delay Start
button, and then set up
the intended value.
• Scope of setting value is H0 to H4.
3
Press the
Start
button to save the setting.
• The power turns off after saving.
NOTE
• The
Salt Refill
n
icon turns on in the display if
dishwasher salt is not in the softening system.
• If the hardness setting is set to H0, no icon
indicates in spite of no salt.
Filling with Dishwasher Salt
The salt dispenser must be filled with salt before
starting the washing programme. In case of
insufficient salt, the
Salt Refill
n
icon indicates on
the display, unless the hardness level has been set
to H0.
CAUTION
• Once you have filled with dishwasher salt you
must run the Rinse cycle immediately to remove
the salt and the salt water around the inner tub
in order to prevent corrosion.
Water Hardness
Softeni
ng level
Ratio
ppm
°d
°e
°f
mmol/l
(Ca+Mg)
mg/l
(Ca)
Range
0
<4
<5
<7
<0.7
<29
Soft
H0
-
75
4 - 7
5 - 9
7 - 13
0.7 - 1.3
29 - 50
H1
1:24
125
7 - 14
9 - 17.5
13 - 25
1.3 - 2.5
50 - 100
H2
1:7
250
14 - 21
17.5 - 26
25 - 38
2.5 - 3.8
100 - 150
H3
1:4
375
>21
>26
>38
>3.8
>150
Hard
H4
2:1
Содержание DFB325 Series
Страница 3: ...TROUBLESHOOTING Before Calling for Service 49 ...
Страница 55: ...Memo ...
Страница 56: ......