18
INSTALLATION
Method 1
When the drain hose is connected to a waste
spigot, the hose must be looped up to the
underside of the bench top and secured.
Method 2
When the drain hose is connected to a separate
standpipe
a
, it is essential that an airtight
connection
b
be made. If not, it can induce odours.
• Standpipe diameter is at least 40 mm.
Preparing Water and
Electrical Connections
Connecting the Hose to the
Water Tap
Connect the water supply hose
a
to the water tap.
WARNING
• Do not shorten or damage the water supply hose
as it contains electrical wires and components. It
can not be detached or removed from the
appliance for installation purposes.
• It is important that the water supply hose not be
tampered with, cut, disassembled, pulled, or
kinked. It contains electrical wiring inside and if
damaged, can cause an electrical hazard.
CAUTION
• Only use the threaded nut of the water supply
hose to tighten it to the tap.
• Do not twist or kink the water supply hose when
connecting it to the tap.
• This appliance may be fed with either hot or cold
water. If the water connection can not be
maintained below 65ºC, the appliance must be
connected to cold water.
≥ 300 mm
700 – 1000 mm
700 – 1000 mm
≥ 300 mm
Содержание DFB325 Series
Страница 3: ...TROUBLESHOOTING Before Calling for Service 49 ...
Страница 55: ...Memo ...
Страница 56: ......