LFA DTP 25, Руководство пользователя

Страница: 43 / 86

43
Troubleshooting
Sometimes unavoidable issues will occur while operating the DTP 25
®
. Fortunately, there are
several methods to remedy these issues.
Common Machine/Part Issues
Symptom Possible Cause Possible Solution
Machine freezes or locks up
Grease point areas are dry.
Regularly oil and grease all the
Grease Nipple points.
There is excess pressure on the
Upper Drift Pin Assembly.
Lower the pressure on the eccentric
sheave/pressure adjustment. Refer to
page 21 for more information.
The press is being started with the
Upper Punch at a low point. Adjust the starting position so that the
Upper Punch is at the highest point.
Knocking sounds coming from
machine
The Upper Drift Pin Assembly is
slightly off. Adjust the Upper Punch until it is
aligned with the Die's bore.
The Upper Drift Pin Assembly is not
dropping smoothly in the powder
filling stage of the process.
Check that there is not a buildup of
powder between the Lower Punch
and the Die. Then check that the
Lower Drift Pin Assembly has enough
clearance to drop through the hole in
the machine's base.
Heavy resistance during production
The high friction areas are either
unclean, locked, worn out, or not
greased properly.
Clean and apply grease to all high
friction areas on the machine.