32
GA130001441_002_C0
– 09/2016
6.5.3
Operating Concept
From the measurement mode, you can select and change a certain parameter as follows:
Press the pushbutton CH, so as to select the desired measurement channel (only
necessary when wanting to change a sensor parameter)
o
The Para status indicator flashes for the selected channel.
Press the PARA pushbutton for about 2 seconds.
o
You have now invoked the parameter menu.
Use the arrow pushbuttons to select the desired parameter group.
o
The name of the parameter group is displayed.
Press the PARA pushbutton to select the desired parameter.
o
The name and the value of the parameter are displayed.
Use the arrow pushbuttons and to change the value of the parameter.
o
The value of the parameter is changed.
Repeat the last 2 steps so as to change further parameters of the same parameter
group.
After having accessed the last parameter of a parameter group, the instrument will switch
back to the measurement mode. Changes to the parameters become effective immediately
and are automatically saved to the EEPROM.
When the instrument is running in the parameter mode and if for a period of 10 seconds no
changes are made to the parameters, then the instrument will automatically return to the
measurement mode. Any parameter changes made up to this point are automatically saved
to the EEPROM.
NOTICE:
When the instrument is running in the parameter mode, and when not entering
a change for more than 10 seconds, then the instrument will automatically
return back to the measurement mode.
Any changes, which have been entered and confirmed up to this point of time,
are automatically saved in the EEPROM.
