LEYBOLD 230110, Инструкция по эксплуатации

Страница: 31 / 56

GA130001441_002_C0
– 09/2016
31
6.5 Parameter Mode
6.5.1 Selection
By operating the PARA pushbutton for approximately 2 seconds the instrument changes
from the measurement mode to the parameter mode. The Para indicator comes on for the
channel selected in each case. When the instrument is running in the parameter mode and
if no pushbutton is operated for 10 seconds, then the instrument will automatically return
back to the measurement mode. The Para indicator for the channel which was selected in
each case is turned off.
6.5.2 Parameter Groups
In the parameter mode you have access to different parameters. You may view these
parameters or change these with the aid of the arrow pushbuttons. In this way you can
configure the instrument. Table 9, Page 31 depicts all available parameters.
Parameter Groups Parameter


 




 






 



 






Table 9
–
Parameter groups and corresponding parameters
The available parameters have been divided into the following parameter sets:
Switching function parameters (PArA SP)
These parameters affect only the sensor of the selected measurement channel. Per
measurement channel, two switching functions are available.

Chapter 7.1 Switching Function Parameters (PArA SP), page 33.
Sensor parameters (PArA SEn)
These parameters affect only the selected measurement channel. Per measurement
channel, two switching functions are available.

Chapter 7.2 Sensor Parameters (PArA SEn), page 34.
General parameters (PArA GEn)
With the aid of these parameters you can generally configure the instrument. The
parameters apply to all measurement channels.

Chapter 7.3 General Parameters (PArA GEn), page 37.