96
13
Carefully move and turn each bearing until each fits back inside the
bracket hole. The bearings are shaped to fit the holes precisely.
Note:
You may have to hold the pick roller up with one hand while
turning and fitting the bearings with the other.
14
Once the bearings are mounted in the bracket holes, slide the retaining
sleeve back towards the left holding bracket until it snaps into a groove on
the pick roller. If done correctly, the pick roller is fixed in place.
15
Remove the new pick roller 1 from the package and attach a copper
bearing to each end.
16
Slide the left bearing toward the retaining sleeve.
17
Insert the sleeve end of pick roller 1 into the upper hole of the left holding
bracket as far as it goes.
Right bearing
Left bearing
Retaining sleeve
Pick roller 1
Upper bracket hole
Right holding bracket
Left holding bracket
