Leviton PowerSwitch EDSR, Руководство по установке

Страница: 6 / 13

20A RECEPTACLE SEAL INSTALLATION (Figure 5)
NOTE: 20A Receptacle seal components are only to be used when a 20A Receptacle is installed.
If installing a 30A Receptacle no components are required to be replaced.
• Leviton EDSR is pre-assembled with Gaskets for a 30A Receptacle. When using with a
20A Receptacle, the 20A Gasket and Gasket Clamp (included) must be used along with a
WETGUARD
TM
Plug to maintain an environmental rating of IP66, UL Standard 50 and a NEMA
environmental rating of 3R 4X and 12K.
• All parts are self aligning to mating parts (refer to Figure 5) .
NOTE:
The Gasket, and the Gasket Clamp are a
mated pair
. The parts are identified with a
visible mark (“20A” or “30A”) to be used either for 20A or 30A installation.
EDSR is shipped with a 30A Gasket Clamp. For 30A applications, mate with 30A Gasket. For 20A
applications use 20A Gasket and 20A Gasket Clamp.
NOTE: DO NOT MIX ASSEMBLY CONFIGURATIONS.
TO INSTALL SEAL COMPONENTS FOR A 20A RECEPTACLE:
FOR SAFETY, MAKE SURE SWITCH IS IN THE "OFF" POSITION.
1.
Lift Receptacle Cover. Unscrew pre-assembled Gasket Clamp assembly and remove from box.
Set mounting screws aside.
2. 20A Gasket and Gasket Clamp are indentified with a "20A" visible mark (30A Gasket and
Gasket Clamp are marked "30A").
3. With Receptacle Cover open, align Gasket Clamp with rubber Gasket and place this loose
assembly over the Receptacle Opening. Make sure that the circular
“V”
ribs of the Gasket
are within the “V” grooves of the Receptacle Opening and secure with (4) screws previously
removed to 8-10 in. lbs. of torque.
NOTE: New environmental ratings label for 4X, 12K & IP66, are included for device cover when
using a mating Leviton WETGUARD
TM
Plug.
5
Figure 4
EDSR Front View
Affix Receptacle
Voltage Label Here
Affix IP66
Ratings Label Here
Switch Handle
Receptacle Cover