Software
Leuze
electronic
20
ODS 96
Leuze electronic
Teach-In procedure
ODS 96 M/S
©
Position the measured object at the first desired distance. Connect the
teach input for
2
sec. to +U
B
. The LEDs are flashing simultaneously. Re-
connect the teach input to GND. The first switching output is tought. Now,
position the measured object at the second desired distance. Connect the
teach input for
2
sec to +U
B
. The LEDs are flashing alternatingly. Recon-
nect the teach input to GND. The second switching output is tought. In
non-operational mode, the teach input is connected to GND.
6
Software
General description
The programming software can be used either for online programming of the
connected ODS 96 or for the offline generation of configurations. For this pur-
pose, the command Type!, explained in section 6.3.1 "Description of the
Menu Commands" can be used. After starting the program a dialog is dis-
played in which you have to choose a device (see section 6.3 "Starting the
Program"). After the offline generation of a parameter configuration, this con-
figuration can be transmitted to the ODS 96 after connection to the PC has
been established.
The order number for the software can be found in section 4.5 "Accessories".
6.1
Connection of the PC
A special parameter plug is situated behind the plastic cover on the backside
of the ODS 96. Connection between the ODS 96 and the PC is established
by means of the cable included in the shipment.
©
Connect the cable to the parameter plug on the ODS 96 and to a serial
interface on the PC. More information on the definition of the interface can
be found in section 6.3.1 "Description of the Menu Commands".
6.2
Installation of the Programming Software
Requirements for the installation of the programming software:
• Windows 3.1 or Windows 95/98/NT,
• 486 processor or faster,
• 4 MByte RAM,
• 2 MByte free disk space
• and a CD-Rom drive.
