Software
Leuze
electronic
22
ODS 96
Leuze electronic
If an ODS is connected, the following window appears:
Figure 6.3: Start menu before measurement
The software automatically recognizes the connected sensor with its default
settings.
6.3.1
Description of the Menu Commands
File
Under menu item "File" you can switch to parameterization mode or quit the
program.
Type!
Menu item "Type!" enables presetting of parameters and generation of pa-
rameter files without connected ODS. In this menu you can choose a device
for which parameter files should be defined.
Options
The following three possibilities are offered under "Options":
• Language selection to choose the language for dialogue.
• Interface to choose the port to which the cable to the ODS is connected
(standard: COM 1). The programming software automatically recog-
nizes the interface used. Choosing a different port could become neces-
sary if more than one sensor is used.
• Change password: first enter your old, then your new password and
confirm with OK.
?
Choose About..., for information on programming software ( product, pro-
gram, device version, as well as for the address of Leuze electronic).
6.3.2
Programming and Adjustment Possibilities
At this point, the various programming possibilities will be explained. As al-
ready mentioned, the software offers an extended functionality. For program-
ming purposes, proceed as follows:
Switching to Parameterization Mode
©
Klick on Parameterization in the start window.
