Leuze 50117911, Оригинальная инструкция по эксплуатации

Страница: 149 / 231

Starting up the device - RS 485 Modbus interface
Leuze electronic GmbH + Co. KG CML 730i 149
Overview
System commands (group 1)
CML 700i status information (group 2)
The following abbreviations for data types apply in the following module descriptions:
t08U = type: 8 bit, unsigned CHAR
t08S = type: 8 bit, signed CHAR
t16U = type: 16 bit, unsigned SHORT
t16S = type: 16 bit, signed SHORT
Group Group name
Group 1 System commands (see page 149)
Group 2 CML 700i status information (see page 149)
Group 3 Device description (see page 150)
Group 4 General configurations (see page 151)
Group 5 Extended settings (see page 151)
Group 6 Process data settings (see page 152)
Group 7 Cascading/trigger settings (see page 152)
Group 8 Blanking settings (see page 153)
Group 9 Teach settings (see page 154)
Group 10 Digital IO pin N settings (N = 2. 5) (see page 154)
Group 11 Time module settings for digital outputs (see page 155)
Group 12 Configuration for block evaluation of beam areas (see page 156)
Group 13 Evaluation functions (see page 158)
The system commands trigger a direct action in the CML 700i.
Parameter Index
(hex.)
Response Data
type
Access Value
range
Default Explanation
Command 84 4 bytes t16U RW 1 … 8 1: Reserved
2: Reserved
3: Teach
4: Reboot
5: Reset
6: Save settings
Note:
Processing of the Save command takes up to
600 ms. During this time, no other data/telegrams
are accepted.
The CML 700i status information specifies operating state information or error messages.