Mounting
Leuze electronic
DDLS 508
22
Overview:
• The alignment laser projects a target spot on the opposing side.
In addition to the target spot, the beam optics produce four individual laser spots that are projected
on the floor.
• The device is aligned vertically and horizontally with two alignment screws using the integrated level
and the laser spots that are projected on the floor.
• The second device is mounted on the horizontally opposing target spot with the aid of the supplied
drilling template.
Depending on mechanical conditions, mount the stationary or mobile device with four M5 screws via the
fastening holes in the mounting plate of the device.
The device must be mounted in a vertical position.
• Check the vertical mounting with a separate level.
• Place the level on the edge of the mounting plate.
Connect the device electrically (see chapter 5 "Electrical connection").
The AUT LED (continuous light) indicates that the start-up phase of the device after “POWER on” has
been concluded. After the start-up phase, the operating mode can be changed.
Switch on the alignment laser.
Activate the LAS (Alignment laser) operating mode to switch on the alignment laser (see chapter 6.1).
The alignment laser projects four spots along a straight line on the floor and a target spot on the opposing
wall.
1
Laser spot 1
2
Laser spot 2
3
Laser spot 3
4
Laser spot 4
5
Alignment laser
6
Target spot
Figure 4.4: Alignment laser
The distance of the laser spots is dependent on the mounting height of the device. The values in the table
will help you find the laser spots on the floor (see table 4.2).
For marking and for better visibility of the laser spots on the floor, four self-adhesive labels are included in
the package.
Data transmission is active while changing the operating mode and with activated alignment
laser.
5
6
1
2
3
4
