Page 8 of 19
STEP 15
STEP 16
STEP 17
Using two (2) 1/4-20 x 1”
Button Socket Head Cap Bolt
[EE]
, two (2) 1/4-20 Lock
Washers
[HH]
, two (2) 1/4” x
1” Fender Washer
[FF]
, two
(2) 1/4” Washer
[GG]
and
two (2) 1/4-20 Weld Nut
[JJ]
secure the holes located on
the sides of the Tray
[V]
. [Fg.
26 & 27]
NOTE:
The larger 1/4” x 1”
Fender Washer
[FF]
must be
installed on the outside of the
Fixed Lid while the smaller 1/4” Washer
[GG]
must
be installed from inside the Tray
edge.
REQUIRED TOOL: 7/16” SOCKET & 5/32” ALLEN WRENCH
[Fg. 26]
[Fg. 28]
[Fg. 29]
[Fg. 27]
EE
HH
GG
FF
JJ
BB
BB
BB
V
Pull the weather-stripping away from the
vertical edges of the Fixed Lid
[BB]
.
Position and align the Angles
[QQ]
on the
inside of the Fixed Lid
[BB]
as shown. [Fg. 28]
Working from the top of the Angle
[QQ]
,
reinstall the weather-stripping over the edge of
the Angle held against the lid (be sure to hold
the angle completely flush with the edge of the
carrier until fully installed). [Fg. 29]
Crimp the lip of the weather-stripping over the
Fixed Lid
[BB]
and Angle
[QQ]
to provide a
tight grip.
Install all four (4) Drain Plugs
[AA]
into the large holes in the bottom
of the Tray
[V]
. [Fg. 30]
WEATHER
STRIPPING
WEATHER
STRIPPING
[Fg.30]
AA
V
Weather Stripping may disengage from lid during transit due to unnatural pressure from tightly nested lid
during shipping. Simply follow procedures to re-apply.
