Page 6 of 19
Mount each LED Light onto a LED Mount
Bracket
[UU]
with supplied hardware in
the order shown. [Fg. 18]
OPTIONAL:
Optional License Plate
Brackets
[TT]
may also be included in-
between supplied hardware on one LED
Light only, as shown for the mounting of a
vehicle license plate. [Fg. 21]
STEP 11
With the Hat Brackets
[P]
from STEP 5 & 6 still loosely secured, position the carrier along the Slide Tubes
[M]
to adjust for
required vehicle clearances (user discretion). Once the final clearance adjustments are made, verify Slide Tubes are slid
all the way against the Rubber Bummers
[L]
and fully secure all Hat Brackets
[P]
and hardware from Steps 5 & 6.
NOTE:
Users wanting
less clearance
between the tow vehicle and carrier should position the Hat Brackets
[P]
closer to
the vehicle on the Slide Tubes
[M]
[Figure 16].
NOTE:
Users wanting
more clearance
between the tow vehicle and carrier should position the Hat Brackets
[P]
further
away from the vehicle on the Slide Tubes
[M]
[Figure 17].
IMPORTANT:
The Hat Brackets
[P]
must be positioned forward of the Handle Silent Hitch Pin
[D]
location.
Be sure to
allow room for the Silent Hitch Pin with Handle to turn and operate as required.
DO NOT ALLOW HAT BRACKETS [P] TO OVERLAP THE 3.5” WARNING LABEL LOCATED
ON ON THE SLIDE TUBE.
Failure to do so will permit over-extension of the safety cable allowing
the capsule to slide off and cause damage or personal injury.
WARNING:
MIN INSTALLED CLEARANCE
MAX INSTALLED CLEARANCE
M
M
P
P
D
D
WARNING
WARNING
[Fg. 16]
[Fg. 17]
STEP 12
REQUIRED TOOL: 1/2” WRENCH
REQUIRED TOOL: 7MM WRENCH & PHILLIPS HEAD SCREW DRIVER, TWO (2) 7/16
WRENCH OR SOCKET (OPTIONAL)
[Fg.19]
UU
TT
SS
[Fg. 18]
UU
SS
USER-SUPPLIED
LICENSE PLA
TE
VV
WW
TT
XX
[Fg.20]
