Page 5 of 19
STEP 10:
REQUIRED TOOL: 10MM SOCKET OR WRENCH
Z
Y
N
STEP 9
[Fg.12]
Never operate the carrier’s slide-out function without the Safety Cable
[R]
fully secured. Failure to follow proper
procedures may result in bodily injury and property damage.
WARNING:
R
Attach the carabiner to the Safety Cable
[R]
. From
underneath the carrier, connect the carabiner end of
the Safety Cable
[R]
to the “1st Position” hole in the
frame of the TwinTube
[A]
. [Fg.12]
NOTE:
The Safety Cable
[R]
can be secured in two
positions. Secure the Safety Cable to the first position.
For maximum installed clearance needs, the second
position may be used.
A
W
2ND POSITION
1ST POSITION
Place the LED Light wiring
[SS]
over the wings pointing the left
and right Lights towards their
respective corners and the 4-flat
connection towards the vehicle.
Place the Tray
[V]
over the Wiring
[SS]
and Wings
[N]
and line up
the holes in the tray with the holes
in the Wings.
Install a 1/4-20 Hex Head Bolt
[W]
and a 1/4" x 1-1/4" Fender
Washer
[Z]
in each hole in the
bottom of the Tray
[V]
through
to the Wings
[N]
. Secure each
bolt to the Wing with a 1/4" Flat
Washer
[Y]
and a 1/4-20 Nylock
Nut
[X]
. [Fg. 13]
NOTE:
The
larger
1/4” x 1-1/4”
Fender Washer
[Z]
must be
installed inside of the carrier while
the
smaller
1/4” Flat Washer
[Y]
must be installed from underneath
the carrier. [Fg. 14 & 15]
X
V
W
N
Y
X
Z
V
[Fg.14]
[Fg.13]
[Fg.15]
SS
POSITION SIDE OF
TRAY WITH TWO
HOLES CLOSEST TO
VEHICLE.
SS
