Information LH100 V3.6
59
“STV” stands for starting voltage
(CV2).
“MAX” stands for maximum speed
(CV5). Please note that not all
decoders use CV5.
If you want to show the value of one of the settings (CVs), press
‘Enter’, when the setting is displayed,. To change the value key in the
desired value followed by 'Enter'. To read out the value in the CV
pressing ‘Enter’ without entering any new value. (the same as reading
and writing a locomotive address described previously).
11.3.4 Reading and writing by entering the CV — step by
step directions
Many additional decoder CVs can be written and read, in addition to
the settings that can be programmed with the “DIR” menu,.
Depending on the number of the CV you choose, the display will be
different:
CV 1 – 99:
CV 100 – 999:
CV 1000 – 1024:
While we will only show CV1 here as an example, the procedure is the
same for all CVs,
Press
On the display you see
Explanation
The most recently selected
menu is shown
(flashes)
Select “Programming on the
programming track”
The most recently chosen
programming mode is shown.
Use the ‘-’ key to page to the display
of “CV”.
