Lenovo ThinkSystem SR950, Руководство по установке, Страница: 307 / 390

CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
“ ” on page 56 “ ” on page 254
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Before you install an adapter in slot 10 to 15, make sure that there is no filler installed in the slot where you
are installing the adapter.
Important:
You must remove the riser from the I/O tray before installing an adapter. If you are installing a
network adapter (with an RJ45 connector), make sure that there is sufficient clearance to disconnect the
Ethernet cable from the adapter after it is installed.
Note:
If you are installing an adapter in slot 14 or 15, the slot 14 to 15 riser bracket or a riser bracket filler
must be installed on the riser. See “Install the riser bracket for slot 14 to 15 (riser 2)” on page 367
Complete the following steps to install an adapter in slot 10 to 15.
Watch the procedure
. A video of the installation process is available:
•
YouTube
•
Youku
Figure 74. Adapter installation (slot 10 to 15)
Step 1. Open the retention latch.
Step 2. Align the adapter with the riser slot and insert it; then, press the adapter into the riser until the
connector is fully seated.
Step 3. Close and lock the retention latch.
If you have no other operations to perform on the riser after installing an adapter in slot 10 to 15:
Appendix B. Component reference
303