Lenovo RackSwitch G8264CS, Справочник команд интерфейса командной строки

Страница: 677 / 702

© Copyright Lenovo 2017 Appendix A: Lenovo N/OS System Log Messages
677
SERVER link {down
|
up} on port <port>
SSH (remote disconnect msg)
SSH <username> ( <user type> ) {logout
|
ejected
|
idle timeout
|
connection
closed} from {Console
|
Telnet/SSH}
SSH <username> ( <user type> ) login {on Console
|
from host <IP address> }
SSH Error in setting the new config
SSH Failed login attempt via SSH
SSH New config set
SSH scp <username> ( <user type> ) {logout
|
ejected
|
idle timeout
|
connection closed} from {Console
|
Telnet/SSH}
SSH scp <username> ( <user type> ) login {on Console
|
from host
<IP address> }
SSH Wrong config file type
SYSTEM Change fibre GIG port <port> mode to full duplex
SYSTEM Change fibre GIG port <port> speed to 1000
SYSTEM Changed ARP entry for IP <IP address> to: MAC <MAC address>,
Port <port> , VLAN <VLAN>
SYSTEM Enable auto negotiation for copper GIG port: <port>
SYSTEM I2C device <ID> <description> set to access state <state> [from CLI]
SYSTEM Port <port> disabled
SYSTEM Port <port> disabled due to reason code <reason code>
SYSTEM rebooted ( <reason> )[, administrator logged in]
Reason:
 Boot watchdog reset

console PANIC command
 console RESET KEY
 hard reset by SNMP
 hard reset by WEB ‐ UI
 hard reset from console
 hard reset from Telnet

low memory
 MM Cycled Power Domain
 power cycle
 Reset Button was pushed
 reset by SNMP
 reset by WEB ‐ UI
 reset from console

reset from EM
 reset from Telnet/SSH
 scheduled reboot
 SMS ‐ 64 found an over ‐ voltage
 SMS ‐ 64 found an under ‐ voltage
 software ASSERT

software PANIC
 software VERIFY
 Telnet PANIC command
 unknown reason
 watchdog timer
Thread LOG_NOTICE Message (continued)