Lenovo D1212, Руководство по установке и обслуживанию оборудования

Страница: 124 / 154

state
1 = Enable locate indication on ops panel
0 = Disable locate indication on ops panel
Example:
0+03:49:13.187 M0 GEM> hid_set_ident 1
Enclosure identify status = set
0+03:55:43.808 M0 GEM> hid_set_ident 0
Enclosure identify status = cleared
0+03:56:39.021 M0 GEM>
ipconfig
Configures the ESM’s Ethernet management port. Some changes may require a reboot of the ESM to
activate. When run with no arguments, the current IP information is displayed.
Syntax:
ipconfig [option]
option
•
ether <state>
Enable or disable the management Ethernet Port. Changes must be activated by rebooting The ESM.
state
enable Enable the Ethernet port
disable Disable the Ethernet port
•
dhcp <state>
Enable or disable DHCP address assignment. A valid static configuration must be present for the disable option to be successful.
state
enable Enable DHCP
disable Disable DHCP
•
Telnet <state>
Enable or disable telnet CLI access.
state
enable Enable telnet CLI
disable Disable telnet CLI
•
ip <addr> <netmask> [gateway]
Set the static IP configuration for the port. These settings will only apply if DHCP address assignment is disabled.
addr The IPv4 address to assign to the Ethernet port
netmask The subnet mask to assign to the Ethernet port
gateway
An optional default route to be used by the Ethernet port
•
dns <dns1> [dns2]
Set any static DNS addresses. These settings will only apply if DHC address assignment is disabled.
104
Lenovo Storage D1212/D1224/D3284Hardware Installation and Maintenance Guide