Lennox LI009HI-380P432, Руководство пользователя

Страница: 32 / 36

Test operation
Test and operation
●
●
1.
●
●
2.
●
Preparation of test operation
The client approves the air conditioner.
Specify the important notes for air conditioner to
the client.
6.
Leakage detection
Use vacuum pump
Tighten the screw caps of valves and refriger-
1.
2.
5.
ant charging vent.
1.
Reinstall the handle. 7.
tus for 1-2min to check if the pressure of piezo-
meter remains in -0.1MPa. If the pressure de-
creases, there may be leakage.
Remove the piezometer, open the valve core
of liquid valve and gas valve completely with
inner hexagon spanner.
piezometer
valve cap
liquid valve
Lo Hi
gas valve
refrigerant charging
vent
nut of refrigerant
charging vent
close
open
vacuum pump
inner hexagon
spanner
for 10-15min to check if the pressure of piezo-
meter remains in -0.1MPa.
4. Close the vacuum pump and maintain this sta-
2 5
2.
3.
Open the piezometer completely and operate
Remove the valve caps on the liquid valve and
refrigerant charging vent of gas valve and then
connect the other charging hose to the vacuum
pump.
With leakage detector:
Check if there is leakage with leakage detector.
With soap water:
If leakage detector is not available, please use
soap water for leakage detection. Apply soap
water at the suspected position and keep the
soap water for more than 3min. If there are air
bubbles coming out of this position, there's a
leakage.
gas valve and the nut of refrigerant charging vent.
Check after installation
● Check according to the following requirement
after finishing installation.
Possible malfunction
The unit may drop, shake or
emit noise.
Connect the charging hose of piezometer to the
Is water drained well?
It may cause condensation
and water dripping.
Items to be checked
Has the unit been
installed firmly?
Have you done the refri-
gerant leakage test?
It may cause malfunction or
damage the parts.
Is electric wiring and pip-
eline installed correctly?
It may cause malfunction or
damage the parts.
Is the unit grounded
securely?
Does the power cord fol-
low the specification?
It may cause malfunction or
damage the parts.
Is there any obstruction in
the air inlet and outlet?
It may cause insufficient
cooling(heating) capacity.
It may cause malfunction or
damage the parts.
The gas valve and liquid
valve of connection pipe
are open completely?
The dust and sundries
caused during installation
are removed?
Is heat insulation of pipe-
line sufficient?
It may cause condensation
and water dripping.
It may cause electric leakage.
Is the inlet and outlet of
piping hole been covered?
Is the voltage of power
supply according to the
voltage marked on the
nameplate?
It may cause insufficient
cooling(heating) capacity.
It may cause insufficient
cooling (heating) capacity.
It may cause insufficient
cooling (heating) capacity
or waste electricity.
Method of test operation
s e r p , r e w o p e h t h g u o r h t t u P s " " button on
the remote controller to start operation.
Press MODE button to select AUTO, COOL, DRY ,
FAN and HEAT to check whether the operation i s
normal or not.
If the ambient temperature is lower than 16
℃
, e h t
air conditioner can’t start cooling.