Lennox LI009HI-380P432, Руководство пользователя

Страница: 15 / 36

8
FAN button
3
Note:
● For preventing cold air, after starting up heating mode, indoor unit will delay 1~5
minutes to blow air (actual delay time is depend on indoor ambient temperature).
● Set temperature range from remote controller: 16~30
℃
(61-86°F);
Fan speed: auto, low speed, low-medium speed,medium speed, medium-high
speed,high speed.
TURBO button
4
Under COOL o r HEAT mode , press t his button to tu r n to quic k COOL o r qu ic k
HEAT mode. " " icon is displayed on remote controller. Press this button again
to exit turbo function and " " icon will disappear.
If start this function, the unit will run at super-high fan speed to cool or heat quickly
so that the ambient temp. approachs the preset temp. as soon as possible.
▲
▲/ button
5
● Press "▲" or " " button once increase or decrease set temperature 1
℃
(°F).
Holding "▲" or " " button, 2s later, set temperature on remote controller will
change quickly. On releasing button after setting is finished, temperature indica-
tor on indoor unit will change accordi n gly. ( T emperature can’t be adjusted under
▲
▲
This button is used for setting Fan Speed in the sequence that goes from AUTO,
to then back to Auto.
,
, ,
,
Auto
Medium speed Low-Medium speed Low speed
High speed Medium-High speed
● It’s Low fan speed under Dry mode.
This function indicates that moisture on evaporator of indoor unit will be blowed
after the unit is stopped to avoid mould.
Having set X- F AN function on: After turning off the unit by pressing ON/OFF
button indoor fan will continue run n ing for a few minutes. at low speed. In this
period, Hold fa n speed button f o r 2 s to stop indoor fan directly.
Having set X- F AN function off: After turning off the unit by pressing ON/OFF
button, the complete unit will be off directly.
X- FAN f un c t i on Hold fa n speed button f o r 2 s i n COOL o r D RY mode , t he ic on “ ” is
displayed and t he indoor fa n will c ont inue opera t i on f o r a few mi nut es i n order to dry
t he ind oo r un i t eve n though you have turned off the unit. After energization, X-FAN
OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
●
●
●
Note:
Introduction for buttons on remote controller