Lennox BAC020SNM, Инструкция по установке, эксплуатации и обслуживанию

Страница: 102 / 137

CLIMATIC 50 – ROOFTOP – VERSION 23
BALTIC R410A-IOM-0708-E Page 101
DC50 COMFORT & DM50 MULTI CUSTOMER DISPLAY
Function
This display is connected remotely; it is intended for users with no technical knowledge. This display gives access to general
operating data of the unit; it does not give access to detailed operating data.
It can be used to set or change the programming of the various time periods and the temperature set point for each period.
It also has the ability to set a 3 hour override and force an unoccupied mode, or any other different time period,
for a maximum of 7 days. It displays a real time clock and the various fault signals.
Description
Buttons
‘Prg’ Access set points ‘Up’ Access overrides or increase values
‘Clock Access the clock ‘Enter’, Confirms the selection
‘Esc’ Return to the previous display ‘Down’ Access overrides or decrease values
Brightness/Contrast
The display has a set contrast, but this can be adjusted manually. For manual adjustment of the contrast, press the ‘Prg’
and
‘Clock buttons simultaneously and press buttons
 
or
  
to increase or reduce the contrast.
Configuring the terminal address
Sdc.1
The address of the terminal (DC50 or DM50) must be checked after having
switching on the card.
Access the configuration mode by pressing buttons
     
simultaneously for at
least 5 seconds, until the Sdc.1 screen appears.
Press the ‘Enter’
button to
position the cursor over the ‘Setting’ line
With button
 
or
  
set the address of the display. See table below for
the DC50,
the DM50 is always 31, then confirm with button

pLan
address
with
BM50
connected
DC50
Address
pLan
address
with
BM50
connected
DC50
Address
1 17 7 23
2 18 8 24
3 19 9 25
4 20 10 26
5 21 11 27
6 22 12 28