11
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
2. Bracket C in the lower diagram is installed on the face during the
face assembly (see instructions included with face). The captive
screws D on this bracket should be screwed into captive nuts E on
the fireplace. A phillips head screw driver inserted through the vent
holes in the face can be used to complete this task. Align the face for
plumb and level and then tighten all 4 screws.
CAUTION: Any masonry that has been cleaned with an acid
wash must be properly neutralized before installing the fire-
place face. The acid wash will tarnish the face. Consult your
masonry installer.
Face Installation
A number of different faces are available for the Ravelle™ 30 gas fireplace,
however, all the faces are installed in a similar manner. A total of 4 screws
(2 upper and 2 lower) attach the face to the fireplace. To install a face:
1. Locate the 2 screws found in the hardware bag shipped with the face.
Position the face (with the lower door open) in front of the fireplace.
Install the 2 screws (A in the diagram below) through the holes in the
lower door hinge bracket and screw them into the captive nut on tab B
located on the fireplace. Do not fully tighten these screws yet.
A
B
C
D
E
Expanded View
Expanded View
Figure 13
