Lenel m3000, Руководство по установке, Страница: 82 / 118

Controller Firmware Tools
82
M3000 Installation Guide
Connecting Through Network Hub
Answer these questions before continuing:
•
Is there a firewall on the computer you are using to access the Integrated Configuration
Tool?
If yes, disable the firewall in order to use the Integrated Configuration Tool.
•
Is your network using a proxy? If yes, disable the proxy or bypass it.
Complete the Configuration Checklist for the Integrated Configuration Tool on page 91 for each
controller. Then return to this section and proceed with the initial configuration, as described next.
Initial Configuration
By default, the controller’s IP address is
192.168.6.6
. To have your computer communicate with
the controller, you must set your computer IP address to
192.168.6.5
, or similar valid IP address
(
192.168.6.x
where
x
is any number between 1 and 254 except 6).
1.
In Windows, open the Network and Sharing Center .
For more information, refer to “Using OnGuard in the Supported Operating Systems” in the
Installation Guide.
2.
In the View your active networks section of the form, click the Local Area Connection link.
Note:
If you are not currently connected to a network, restore the connection before
continuing. Use the Windows Network Diagnostics tools, or contact your Network
Administrator for assistance.
3.
In the Local Area Connection dialog box, click Properties .
4.
In the Local Area Connection Properties dialog box, select either Internet Protocol Version 4
(TCP/IPv4) or Internet Protocol Version 6 (TCP/IPv6) .
5.
Click Properties .
•
If Obtain an IPvx /Address Automatically is already checked, select Use the Following
IPvx Address , where
x
is the Internet Protocol Version you are using (4 or 6).