Lenel m3000, Руководство по установке, Страница: 36 / 118

PXNplus CPU Board
36
M3000 Installation Guide
UCSIMMPlus Board LED Indicators on the PXNplus Board
Important Information for Firewall Users
If your installation requires any controller and its corresponding host to communicate through a
firewall, then the firewall must be configured to allow for connections through a specific port.
When OnGuard is used with the products listed below, firewall port 3001 (default) must be open.
•
Integrated Configuration Tool
•
DirecDoor
•
M5PXNplus
•
M2000PXNplus
•
M3000PXNplus
Note: The default port (3001) can be changed using the ICT. Refer to Integrated Configuration
Tool (ICT) on page 81 .
Configuring Upstream Communications with the Host
1.
Verify that you have a working network. If you need to configure before your network is running,
go to step 3.
2.
Connect the network cable into J1, the Ethernet connector. Refer to Regulatory Information on
page 93 .
3.
Use the Integrated Configuration Tool to set the board to network use. The default for this board
is network, so you may only need minimal set up. Refer to
Controller Firmware Tools on page
81 .
LEDs Color Purpose (Type 2 SIMM and Type 3 SIMM)
DS1 and DS5 Green ON - Link activity present.
OFF - No link activity present.
Flashing - Network activity detected.
DS2 and DS6 Yellow ON - 100 Mbps
OFF - 10 Mbps
DS3 and DS7 Red ON - Full duplex
OFF - Half duplex
DS4 and DS8 Red ON – Collision