Lencore G8350, Руководство по эксплуатации

Страница: 8 / 35

1. RESET Button
The Reset button is used to make a
hardware reset for servicing purposes.
2.
Protocessor LEDs The Protocessor
LED’s display the status of the
Protocessor.
3. LED Indicators
The LED indicators display various
conditions and functions such as
network activity and relay status. See
“Using the System” for detailed
information.
4. Switches
The switches are used to make a
number of adjustments to the system
without using a computer.
5. LCD Display
The LCD displays various diagnostic
messages and configuration information
about the system.
6. Protocessor
Connect an Ethernet cable to access
the Protocessor.
(not supervised)
7. Aux Relays
The Aux Relay R1 is used to send a
fault to the FACP. The other relays are
for future use.
(supervised by FACP)
8. RS232
For future use.
9. Inputs 1-4
Supervised Input 1 is used to mute the
masking. Connect the FACP mute
output here.
(supervised)
10. Inputs 5-8
For future use.
(supervised)
11. Inputs 9-12
Input 11: UPS AC Fault.
Input 12: UPS Battery Fault
Inputs 9 &10: Future Use.
(supervised)
12. Data In/Out
Connect the Data Out to the first OP
Data In . The Data in is for future use.
(not supervised)
13. GND
Connect a common audio ground wire
from the GND connector to the first OP.
14. UPS Power In
Connect UPS power here or jumpers if a
UPS is not used.
(not supervised)
15. Power Input
Power cord connector (IEC 60320).
110-240 VAC.
(not supervised)
3