7
WARNING! Do not expose the chair to an excessively humid environment. If the chair
gets wet, remove the plug from the outlet and have it checked by an Authorized Service
Centre.
The chair has been designed and built to operate in a closed and dry room. The ambient operating condition are:
• temperature: 5° ÷ 40° C
• humidity: 30% ÷ 75% without condensation.
If the environmental conditions are particularly critical it is advisable to provide the room with an adequate
air conditioning system to bring the humidity and temperature values within acceptable limits.
3. ENVIRONMENTAL WORKING CONDITIONS AND STORAGE
2.8. Instructions to replace fuse
To replace fuses, open the small part on the panel board with the symbol
WARNING! It is strongly recommended to insert the plug into a single outlet exclusively
reserved to the device. We do not recommend the use of multiple sockets (power strip),
adopters and patch cords. The cable must not be bent.
WARNING! Before plugging in the cable, make sure that it is not twisted or bended and
make sure that the protective sheath is undamaged.
WARNING! The chair must be positioned in order to ease the removal of the electric
plug.
WARNING! To avoid the risk of electrical shock, this chair must exclusively be plugged in
power supply grids with protective ground.
WORKING CONDITIONS: WARNING! The chair was not conceived to be used in settings with
explosive atmospheres, in presence of thin powders or corrosive gases, acids, corrosive agents
or salt.
Neither it is recommended to use the chair in presence of ionizing and not ionizing radiations (x
rays, lasers, microwaves, ultraviolet rays).
- Not intended to be used in oxygen rich environments.
- Not intended to be used with flammable anesthetics or in conjunction with flammable agents.
STORAGE! For the correct functioning of the electrical equipment the storage of the chair must
be at a temperature between -25° C and +55° C, and only for short periods not exceeding 24
hours, to +70°C. The chair has no special requirements for storage, provided that it takes place
in a closed and dry rooms; this condition should also be ensured during all phases of transport.
%