Lektro-Vend Combo Series, Руководство по обслуживанию

Страница: 45 / 93

SOLENOID COVER PANEL REMOVAL
At some time it may be necessary to remove the cover over the solenoids for service or maintenance located
on the back side of the cold food door. To remove the cover open the front door of the machine. Then open
the inside cold food door. Located on the back side of the cold food door is the solenoid cover. Take hold
of the solenoid cover at the top and bottom and lift up firmly on the panel. The panel should move upward
about allowing you to then remove the panel. Set the cover to the right out of the way. To reinstall the
cover, reposition the cover, making sure that all points are latching. Slide the cover downward about
Make sure that the cover is securely latched in place. If one of the latches is missed the cover may rub on
the carousel trays in that area. Close the front door and ensure that the cover is not rubbing against the
carousel.
ASSEMBLY REMOVAL
To remove the chiller assembly from the machine, unplug the cooling unit from the power box. In the lower
left hand corner in front of the chiller is a metal clip held in place with a screw. Remove the screw and clip,
take the screw out of the door stop and open the front door fully to prevent the chilelr from hitting the door.
On the left hand side of the chiller unit in the front area, in the bottom of the machine is the lever for lowering
the cooling unit. Take hold of the lever and lift it up. The cooling unit will drop down in the front. Unplug the
chiller and open the harness wire guide. You can then lift up on the unit and slide it out the front of the machine.
The gasket material may stick to the bottom of the cabinet and it may be necessary to clean this area once
unit is removed. Caution should be used to avoid catching the wiring harness above on the cooling unit as it
is removed.
To install the replacement unit make sure the gasket material around each opening clean and has a small
amount of talcum power on it to allow the gasket to slide and prevent sticking. Caution should be used when
sliding the cooling unit into the machine to avoid the back gasket catching on the back opening and rolling
the gasket out of place. Ensure that the wiring harness above the cooling unit does not catch on the cabinet
when the unit is being installed. Install the replacement unit by sliding the unit in with the power cord facing
you. Once the unit is in position in the chiller rack, push down on the lowering lever and the cooling unit will
rise up and seal the openings to the refrigerated area. Install the retaining clip and screw
on
the left
front
corner.
Make sure that the cooling unit is lined up with the cabinet openings and that there is a good seal around the
outlet not allowing cold air to escape. Plug in the service power cord and loop the power cord so it can not
get caught under the cooling unit. Make sure the harness above the cooling unit did not get caught in the front
gasket. Allow the unit to run one hour before making adjustments to the cooling unit thermostat. The unit
should be set up to run between
to Failure to properly adjust the cooling unit thermometer may cause
problems and the unit not to cool properly.