Lektri-Co 1P7K, Руководство пользователя и инструкция по установке

Страница: 5 / 42

1P7K user and installation manual 5
1. SAFETY INSTRUCTIONS
ELECTRICAL WARNINGS
Before starting to install and operate the 1P7K charger,
the user must always read this document very carefully,
take into consideration all the warnings and follow all the
instructions as described in this manual.
Failure to do so may result in electric shock which can be
fatal or cause serious physical injuries.
DO NOT open the front cover when the 1P7K charger is
functioning, electric shock hazard.
DO NOT touch the connector’s pins.
DO NOT insert any tools inside the type 2 vehicle
connector.
DO NOT touch any pins, electronic components and
terminals on the printed circuit board (PCB) to avoid
electrostatic discharges (ESD) that could damage the
product.
Never install a product that is damaged.
Failure to do so may result in electric shock and/or
material damages (electric vehicle included).
1P7K charger must always be installed by qualified personnel and in
accordance with the electrical regulations applicable in your country.
1P7K charger is an electrical device that is always connected to 230VAC
therefore touching uninsulated parts (e.g. interior PCB pins, connectors,
uninsulated parts of the wires) will result in an electric shock.
If opening the front cover is necessary (e.g. during installation), always cut off
the power supply of the charger from the dedicated circuit breaker.
The 1P7K charger must be operated only by adults.
Adaptors, conversion adapters and cord extension sets are not allowed to be
used!
Stop the supply in case the Red LED appears!
CAUTION
CAUTION
ESD CAUTION
CAUTION