Lektri-Co 1P7K, Руководство пользователя и инструкция по установке

Страница: 16 / 42

1P7K user and installation manual 16
2. Inspect the charger for any damages. The main components of the 1P7K
charger described in step 1, must not reveal any cracks, defects or other
imperfections. Also, the electrical insulation of the included charging
cable must be intact. If defects are found, do not proceed with the
installation process and immediately contact the manufacturer or the local
supplier. For contact details please see section 8.2 Support.
CAUTION
Never install a product that is damaged.
Failure to do so may result in electric shock and/or
material damages (electric vehicle included).
3. Determine the best place for the charger to be installed, taking into
consideration the recommendations described in section 4.2 Plan the
installation.
4. Mark on the wall the position of the charger’s 3 mounting points. For a
quick and correct marking of the mounting points please use the provided
drilling template. It is recommended to install the 1P7K charger at 1,3m
above the floor.
5. Drill holes in the wall where the
mounting points are marked. The
diameter of the holes depends
on what type of screw anchor
are used. Always use anchor
screws dedicated to your wall
surface (e.g. brick/concrete,
drywall, polystyrene insulation)
and follow the recommendations
of the anchor screw
manufacturer. Anchor screws and
corresponding screws are not
included.
6. Insert the screw anchor into the
holes and make sure they are
inserted all the way. If necessary,
use a hammer and gently tap the
anchor screws all the way into
the holes.
7. Using a step drill bit, drill a 30mm
diameter hole into one of the
existing precut areas from the
Fig. 4 Drilling template for the 1P7K charger’s
mounting points