21
Programming acknowledged
Successful remote programming of a calling number or calling number sequence
Programming, abort
Faulty remote programming of a calling number or calling number sequence
Sensor
n
activated
Announcement if sensor
n
is still in alarm mode
Supervision (I/II/III) < due to
noise / sensor
n
> activated
Confirmation of DTMF 5 : announcement of the activated supervision functions,
indicating the supervision modes in accordance to the position of the
selection
switch
(I/II/III)
Supervision (I/II/III) activated
Confirmation of DTMF 9 : Switch to
active supervision mode
an announce
monitoring functions at current position of the
selection switch
(I/II/III)
Supervision (I/II/III) deactivated
Confirmation of DTMF 7 : Switch to
inactive supervision mode
an announce
monitoring functions at current position of the
selection switch
(I/II/III)
Unacknowledged alarms:
n
Quantity of unacknowledged alarms
8.3 Functional checks
8.3.1 Test-call
We strongly advise to make a
test-call
to check functionality of
before starting operation.
8.3.2 Test alarm functions
Even though the alarm unit is maintenance free (except the battery) a periodical function test should be carried out,
especially:
Emergency button
Wired sensors
Acoustical monitoring
8.4 Battery check / replacement
If the announcement „Battery error“ is initiated after switching on
, the battery should be replaced
immediately as follows:
1.
Slide
function switch
to OFF
2.
Disconnect
from the
telephone network, by removing the telephone cord
3.
Open battery compartment and remove old battery
4.
Insert new battery and close battery compartment
5.
Reconnect telephone cord to
Notes:
Always use fresh 9V-batteries
Dispose the old battery properly
8.5 Maintenance
Slide
function switch
to OFF and remove telephone cord. Clean
if necessary using a moistened cloth and dry
it afterwards.
Note:
Do not use cleaning agents or solvent