Page 4
2018-05-18
IncodeX One Point-to-Point
Broadcasting Solution
Using the included straight-through RJ-45 Eth-
ernet cable, connect the IncodeX One
Ethernet
port directly to a cable or DSL modem or to a
10/100 BASE-T switch on your TCP/IP network.
To check your network connection, look at the
Ethernet LEDs above the Ethernet port and
compare to the table at left.
IncodeX One Ethernet LED Indicators
LED Position
State
Description
Left
Off
Connection speed is 10Mb/s
Blinking amber
Connection speed is 100Mb/s
Right
Off
Ethernet link not established
Steady on green
Ethernet link established.
Connect the included power cable to the
power cord connector and then plug the
other end into an AC power source.
SYSTEM INSTALLATION
If using, connect your
analog audio source to
the audio inputs.
LEIGHTRONIX strongly recommends the use of an uninterruptible power supply (UPS) with the IncodeX
One. Damage from power loss or spikes is not covered under warranty.
INSTALLING THE INCODEX ONE
1.
The IncodeX One encoder may be left as a standalone, tabletop unit or mounted into a rack as follows:
a.
Insert the IncodeX One into the rack, aligning the holes of the unit’s mounting bracket with those of the rack.
b.
Secure the IncodeX One to the rack with user-supplied rack screws.
Leave empty rack spaces above and below the IncodeX One. The IncodeX One should not have any-
thing stacked on top of it.
2.
Attach your network, power, and signal wiring to the IncodeX One according to the instructions below:
If using an analog video source,
connect your source to the com-
posite video input.
If using a digital video
source, connect your source
to the SDI video input.
Not used
Содержание IncodeX One
Страница 4: ......
