31
8. Mounting troughs (‘Trufs’) onto the knife
For room temperature ultrathin sectioning disposable plastic troughs - called ‘Trufs’ - are
used to carry distilled water where the sections float after sectioning.
Fitting a Truf is simple if the Leica EM MP is used
(Fig.42)
.
Wax is melted in the bath of the Leica EM MP, glass knives are lightly warmed on the
hotplate with the knife edge overhanging the edge of the hotplate as shown in
Fig.43
.
The attachment surfaces of the Truf are coated with molten wax by putting it onto the wax
bath as shown in
Fig 43
.
The Truf is then brought into contact with the pre-warmed knife and slid up until it is levelled
with the knife edge as shown in
Fig.44
. The Truf is held in this position for a second or two
until the wax has set.
Additional wax is applied on the right side of the Truf using the spatula supplied with the
Leica EM MP for further protection against leaks
(Fig.45)
.
Содержание EM KMR2
