33
Handling of fuel and oil products
When handling fuel and oil products, bear in mind:
-
Do not let any oil leak on the ground.
-
Use oil qualities recommended by the manufacturer. Do not mix different oil types
and/or brands with one another.
-
When handling oil, always wear appropriate protective equipment.
-
Before refuelling, always stop the combustion engine / electric motor and disconnect
from mains current.
-
Only use fuels recommended by the engine manufacturer. Do not mix any additives
with the fuel.
-
If fuel or oil gets into the eyes, mouth or open wound, clean it immediately with a lot
of water or designated fluid and call a doctor.
Check hydraulic hoses and components only when the engine is stopped and with pressure
released from the hydraulic system. Do not operate the machine if you have noticed faults or
leaks in the hydraulic system. Ejection of hydraulic fluid can cause burns or penetrate the skin
and cause serious injuries. Consult a doctor immediately if hydraulic fluid penetrates your skin.
Wash any body part that has come in contact with hydraulic oil carefully with water and soap.
Hydraulic oil is also harmful to the environment – prevent oil leakages. Only use hydraulic oil
types approved by the manufacturer.
Never handle pressurised hydraulic components, because in
case of failure on a fitting or component, a spray of high
pressure hydraulic fluid can cause the machine to tip over
and result in serious injuries. Do not operate the machine if
you have noticed a fault in the hydraulic system.
Check hydraulic hoses for any cracks and wear. Monitor the hoses for wear and stop operation if
the outer layer of any hose has worn out. Check routing of the hoses, adjust the hose clamps if
necessary in order to prevent chafing. The hose’s expiry date is marked on it. After this date, the
component must be replaced. If any signs of a leak are observed, place a piece of cardboard
underneath the suspected component to determine the source.
If you find a fault, operation of the access platform must be stopped immediately and the hose or
the component must be replaced. Contact the Leguan service.
