LEGRAND MIDDLE ATLANTIC FlexView 800 Series, Инструкция

Страница: 8 / 18

NOTE :
• To order more hardware, contact support at av.support@legrand.com or (866) 977-3901.
• Additional hardware is included that may not be required for your installation.
(8x)
Spacer
(4x)
Washer
INTERFACE HARDWARE (9900-002248)
(4x)
M4 x 12mm
Pan Head Screw
(4x)
M4 x 20mm
Pan Head Screw
(4x)
M4 x 25mm
Pan Head Screw
(4x)
M5 x 12mm
Pan Head Screw
(4x)
M5 x 20mm
Pan Head Screw
(4x)
M5 x 25mm
Pan Head Screw
(4x)
M6 x 12mm
Pan Head Screw
(4x)
M6 x 20mm
Pan Head Screw
(4x)
M6 x 25mm
Pan Head Screw
(4x)
M8 x 12mm
Pan Head Screw
(4x)
M8 x 20mm
Pan Head Screw
(4x)
M8 x 30mm
Pan Head Screw
SUPPLIED COMPONENTS AND HARDWARE (CONTINUED)
REQUIRED TOOLS
WARNING : Use tools with caution and follow all
necessary safety protocols.
AVERTISSEMENT
: Utiliser des outils avec prudence
et suivre tous les protocoles de sécurité nécessaires.
• Protective Eyewear
• Power Driver
• #2 Phillips Screwdriver
• #2 Phillips Bit
• Slotted Screwdriver
• Level
• Toothpick or
Small Straw
• ½” Socket
• 5/16” Socket
• Socket Wrench
• Adjustable Wrench
INSTALLING THE LEVELING FEET (OPTIONAL)
3. Repeat the process to remove all 4 casters from your cart.
NOTE : You can remove the (4x) pre-installed casters
on the bottom of your FlexView Conferencing Cart and
replace them with the provided leveling feet, if desired.
1. With at least one additional person, carefully tip your
FlexView Conferencing Cart over and gently place it onto
an appropriate section of floor to act as a work surface.
2. Use a power driver, ½” socket, and remove
(4x) 5/16-18 flange nuts from the studs on the base
of your cart. Remove caster and set aside the nuts
for leveling feet installation. ( FIGURE B )
FIGURE B
Caster Studs Nuts
WARNING: This procedure requires at least one
additional person.
AVERTISSEMENT : Cette procédure nécessite
au moins une personne supplémentaire.
Page 8
NOTE
: FlexView
Conferencing Cart shown.