LEGRAND CHIEF XSD1U, Руководство по установке

Страница: 8 / 24

XSD1U Installation Instructions
8
Assembly And Installation
The XSD1U can be to be mounted to:
• a bare concrete wall with a minimum thickness of
8" (203mm):
• a bare 8" x 8" x 16" (203mm x 203mm x 406mm)
concrete block wall;
• wood studs spaced 16" or 24" on center with a
maximum drywall covering of 5/8”; or
• a 2" x 4"-25ga minimum steel stud wall.
•
a 1/2" minimum thickness plywood-backed, steel stud
wall covered with drywall having a maximum thickness
of 5/8".
Installing to Wood Stud Wall
1. Use a stud-finder to locate 16" or 24" studs.
2. Place top bracket (B) against wall at desired mounting
location 10 1/8" above the desired center of the screen. Use
a level to ensure a level mount. (See Figure 1)
3. Mark hole locations at each mounting location in the center
of each stud. (See Figure 1)
4. Drill two 7/32” holes at marked hole locations. (See Figure
1)
5. Install two 5/16 x 2 1/2” hex head cap screws (G) through
two 5/16" washers (H), holes on top bracket and into drilled
holes on wall. (See Figure 1)
Figure 1
CAUTION:
Use proper lifting techniques and two people to
install XSD1U assembly onto wall!
6. Carefully hang XSD1U assembly (A) onto top bracket (B),
making sure mount slides behind upper flange on top
bracket (B). (See Figure 2)
Figure 2
7. Remove screw holding bottom cover to XSD1U assembly
(A) and remove bottom cover. (See Figure 3)
Figure 3
8. Mark hole locations for lower two mounting holes. (See
Figure 4)
9. Remove mount (A) from top bracket.
10. Drill two 7/32” holes at marked hole locations. (See Figure
4)
Figure 4
3 4
(G) x 2
5
7/32” (5.3mm)
(B)
(H) x 2
(B)
(A)
6
6
7
7
7
x x
8
10
7/32” (5.3mm)