LEGRAND CHIEF XSD1U, Руководство по установке

Страница: 15 / 24

Installation Instructions XSD1U
15
Height-Adjustment Setup
1. Loosen two hex head cap screws inside outer slots one half
turn each to loosen top bracket. (See Figure 22)
2. Remove top cover from XSD1U assembly. (See Figure 22)
Figure 22
3. Loosen two Phillips screws holding inner cover to XSD1U.
(See Figure 22)
4. Remove inner cover from XSD1U. (See Figure 23)
Figure 23
5. Install control pad bracket (Q) at desired control pad
location. May be installed on either side, top or bottom,
depending on user preference. (See Figure 24)
NOTE:
The control pad (P) may also be installed to the bottom
edge of the display using the double-sided tape (U). If
this is desired, plug the switch directly to port A1 or A2
to initialize and route cable after display is installed.
Figure 24
6. Use #6-32 x 3/8" button head cap screw (M) to secure
control pad bracket (Q) to mount. (See Figure 25)
Figure 25
7. Install control pad (P) onto control pad bracket (Q). (See
Figure 25)
8. Route and connect control pad cable to actuator box into
port A1 or A2. (See Figure 26)
Figure 26
x 2
(half turn)
1
2
2
3
x 2
4
(Q)
(M)
6
(Q)
7
(P)
8
8
actuator
box
control
pad cable