LEGRAND CHIEF XSD1U, Руководство по установке

Страница: 16 / 24

XSD1U Installation Instructions
16
9. Press and hold "DOWN" button for three seconds to
initialize lift mechanism. (See Figure 27)
10. Press and hold "UP" button until mount reaches its
maximum height. (See Figure 27)
NOTE:
If lifting mechanism does not function properly refer to
"Troubleshooting" Section.
Figure 27
11. Attach display power, signal cables as well as peripheral
cables as desired. See Cable Management section for
details.
12. Reinstall inner cover and tighten Phillips screws to secure it
in position. (See Figure 28)
Figure 28
13. Press and hold "DOWN" button until mount reaches it’s
minimum height.
NOTE:
If control pad (P) was installed on either side at the top
of the mount, mount will need to be partially extended
in order to re-install top cover.
14. Re-install top cover and tighten button head cap screws to
secure it in position. (See Figure 29)
Figure 29
15. Re-install bottom cover and secure with removed button
head cap screw. (See Figure 30)
Figure 30
Display Installation
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all accessories and components attached to the XSD1U head
assembly up to (and including) the display does not exceed
310 lbs (140.6 kg). If mounting to a 2" x 4"-25ga minimum
steel stud wall the weight limit is reduced to only 290 lbs
(131.5 kg).
1. Make sure height is at the lowest possible position.
2. Make sure latching flags are in "open" position. (See Figure
31)
Figure 31
"UP" "DOWN"
"PRESETS" "SAVE"
12
12
14
14
x 2 14
15
flags in "open"
position