9
POWER DOWN OPERATION
Use this procedure to lower the base to flat during a power outage. Do NOT put batteries in power down device
until necessary for use.
Note: Power down device uses 9-volt alkaline batteries, which are not included.
STEP 1
Insert (2) 9-volt alkaline batteries into the power brick (FIGURE 5).
STEP 2
Press the FLAT BUTTON on the remote control or in-line switch (if equipped)
(FIGURE 6) to adjust the base to the level position.
FIGURE 5
INSTALL (2) 9 VOLT
BATTERIES
*BATTERIES NOT
INCLUDED
POWER
BRICK
BATTERY COMPARTMENT DOOR
(push in and slide up to remove)
STEP 3
Remove batteries from power brick and discard.
Note: Batteries are good for only one use.
When power is restored from outage, base is ready to resume normal operation.
FIGURE 6
FLAT
BUTTON
IN-LINE
SWITCH
