Short press
button one time
In the network:
Send Wake up notification, and LED will fast blink when
sending data, send over then the LED turn off.
Not In the network:
NOP.
Press and hold
more than 5
seconds
Reset Motion Sensor to factory default.
1. Triggering this action, in 5 seconds LED will be accelerate blink.
After 5 seconds, the LED will remain on until the key is released.
Motion Sensor will send “Device_Reset_Locally” to the main
controller and exclude from the Z-Wave network when the button is
released, this procedure will reset the sensor to factory default.
2.
Please use this procedure only when the network primary controller is
missing or otherwise inoperable.
3.
When not in the network
,
triggering this action, in 5 seconds LED will
be accelerate blink red. After 5 seconds, the LED will remain on red
until the key is released. this procedure will reset the sensor to factory
default.
Motion is
triggered
In the network:
Send Notification report and Sensor multilevel report and
Basic set (Setup configuration parameter 0x0E to 0x01), and the LED will
be turn on 0.2 second.
Not in the network:
Motion sensor is disable.
Tamper switch is
triggered
In the network:
Send Notification report, and the LED will be turn on 0.2
second.
Not in the network:
Tamper switch is disable.
6.2
Caution:
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Hereby, Corporation declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU
