③
Assembly the main body to the bracket.
6.
Product Usage
Function of Action Button:
6.1
All functions of each trigger:
Function Of Action
Trigger
Description
Power on
In the network:
Send Battery report and Wake up notification, the LED
turn on within 1 second.
Not in the network:
Only the LED will be slow blink 3 times.
SmartStart
Inclusion
Add the Motion Sensor into the Z-Wave network via SmartStart:
1.
Add your Motion Sensor device to the
primary controller’s SmartStart
provisioning list (if you don’t know how to do this, refer to its manual) by
scanning your device’s QR code
(located on the side of your device).
2.
The motion will send “Z-Wave protocol Command Class” frame to
start SmartStart Inclusion.
3.
Led will fast blink and solid for 2 seconds to indicate the inclusion is
successful, if inclusion failed, Led will off.
Note:
User should follow the procedure in the section below if the
controller does not support SmartStart inclusion.
Short press
button three
time
Add the Motion Sensor into the Z-Wave network:
5.
Power on your Motion Sensor, and let your Z-Wave controller into
add/inclusion mode.
6.
3 consecutive clicks in 1.5 seconds, the Motion Sensor will send out
a node info security CC in command class list (Security inclusion),
the LED will be fast blink for 30 seconds.
7.
If the inclusion is successful, the LED will be turn on within 2 seconds.
If failed, LED will be turn off forever, and please repeat the steps in
above.
Remove Motion Sensor from a Z-Wave network:
1.
Power on your Motion Sensor, and let the Z-Wave primary controller
into remove mode.
2.
3 consecutive clicks in 1.5 second, the LED will be fast blink for 30
seconds.
3.
If Motion Sensor has been successfully removed from your Z-Wave
network, the LED will be turn on 2 seconds. If failed, LED will be
turn off forever, and please repeat the steps in above.
